power

TerraPower gets OK to start construction of its first nuclear plant

On Wednesday, the US Nuclear Regulatory Commission announced that it had issued its first construction approval in nearly a decade. The approval will allow work to begin on a site in Kemmerer, Wyoming, by a company called TerraPower. That company is most widely recognized as being financially backed by Bill Gates, but it’s attempting to build a radically new reactor, one that is sodium-cooled and incorporates energy storage as part of its design.

This doesn’t necessarily mean it will gain approval to operate the reactor, but it’s a critical step for the company.

The TerraPower design, which it calls Natrium and has been developed jointly with GE Hitachi, has several novel features. Probably the most notable of these is the use of liquid sodium for cooling and heat transfer. This allows the primary coolant to remain liquid, avoiding any of the challenges posed by the high-pressure steam used in water-cooled reactors. But it carries the risk that sodium is highly reactive when exposed to air or water. Natrium is also a fast-neutron reactor, which could allow it to consume some isotopes that would otherwise end up as radioactive waste in more traditional reactor designs.

The reactor is also relatively small compared to most current nuclear plants (245 megawatts versus roughly one gigawatt), and incorporates energy storage. Rather than using the heat extracted by the sodium to boil water, the plant will put the heat into a salt-based storage material that can either be used to generate electricity or stored for later use. This will allow the plant to operate around renewable power, which would otherwise undercut it on price. The storage system will also allow it to temporarily output up to 500 MW of electricity.

Generating power with a thin, flexible thermoelectric film

cooling, materials science, power, Science, thermoelectric material / Rejus Almole / December 12, 2024

The No. 1 nuisance with smartphones and smartwatches is that we need to charge them every day. As warm-blooded creatures, however, we generate heat all the time, and that heat can be converted into electricity for some of the electronic gadgetry we carry.

Flexible thermoelectric devices, or F-TEDs, can convert thermal energy into electric power. The problem is that F-TEDs weren’t actually flexible enough to comfortably wear or efficient enough to power even a smartwatch. They were also very expensive to make.

But now, a team of Australian researchers thinks they finally achieved a breakthrough that might take F-TEDs off the ground.

“The power generated by the flexible thermoelectric film we have created would not be enough to charge a smartphone but should be enough to keep a smartwatch going,” said Zhi-Gang Chen, a professor at Queensland University of Technology in Brisbane, Australia. Does that mean we have reached a point where it would be possible to make a thermoelectric Apple Watch band that could keep the watch charged all the time? “It would take some industrial engineering and optimization, but we can definitely achieve a smartwatch band like that,” Chen said.

Manufacturing heaven

Thermoelectric generators producing enough power to run something like an Apple Watch were, so far, made with rigid bulk materials. The obvious problem with them was that nobody would want to wear a metal slab on their wrist or run a power cable from anywhere else to their watch. Flexible thermoelectric devices, on the other hand, were perfectly wearable but offered efficiencies that made them good for low-power health-monitoring electronics rather than more power-hungry hardware like smartwatches.

Back in 2021, generating 35 microwatts per square centimeter in a wristband worn during a typical walk outside was impressive enough to land your research paper in Nature. Today, Chen and his colleagues made a flexible thermoelectric device that performed over 34 times better at room temperature. “To the best of our knowledge, we hold a current record in this field,” Chen says.

Generating power with a thin, flexible thermoelectric film Read More »